Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Liner & Rebuild Cost in Midland?
Chimney liner and rebuild work in Midland typically runs $450 to $900 for a HeatShield ceramic resurfacing job, $2,200 to $4,800 for a full DuraFlex stainless reline, and $3,500 to $9,000 or more for a chimney rebuild. The final figure depends on the height of the flue, how much of the masonry has broken down, and whether we can restore the existing liner or have to replace it.
Those are typical ranges for the Midland market in 2026, not quotes. Every job gets a written estimate that sets the actual price, and the estimate is free. Call (866) 942-7865 for yours.
Chimney Liner & Rebuild Cost Breakdown (2026)
Here’s how the numbers break down for the work we do most. A sweep and inspection usually comes first, because nobody can price a liner honestly until someone sees the inside of the flue.
| Line item | Typical range |
|---|---|
| Chimney sweep and camera inspection | $150 – $350 |
| HeatShield ceramic flue resurfacing | $450 – $900 |
| DuraFlex stainless steel reline (single story) | $2,200 – $3,500 |
| DuraFlex reline (taller or offset flue) | $3,200 – $4,800 |
| Chimney cap with Gelco products | $180 – $450 |
| Crown repair or rebuild | $400 – $1,200 |
| Partial masonry rebuild (upper stack) | $3,500 – $6,000 |
| Full chimney rebuild to roofline | $6,000 – $9,000+ |
| Dryer vent cleaning | $120 – $250 |
What pushes a job toward the top of a range: a clay liner that’s cracked in more than one place, a flue with an offset that has to be chased through, a chimney that’s pulling away from the house, or a chase that was never capped and has been taking on West Texas dust and rain for a decade. What keeps it low: a liner that’s still sound, a crown that only needs patching, and work done before the damage spreads.
The single biggest price driver in Midland is whether the flue can be saved. A HeatShield application restores a deteriorating clay liner that’s still structurally intact, and it costs a fraction of a full reline. When the liner is beyond that, we install a DuraFlex flexible liner system, which is the professional standard for lining a compromised chimney. Same visit, same call. We don’t hand the job off.
What Affects Chimney Liner & Rebuild Pricing in Midland
- Flue height and shape. A straight 15-foot flue is faster and cheaper to line than a 30-foot chimney with an offset in the middle. Height costs material and labor, and offsets cost time.
- Condition of the original clay liner. Hairline cracks can often take a HeatShield ceramic resurfacing. Spalling, missing mortar joints, or a liner that’s crumbled in sections means a full stainless reline. The camera inspection settles which one you’re looking at.
- Masonry and brick condition. Midland’s dry climate and hot summers are hard on mortar. Chimneys here take a lot of sun and thermal movement, and mortar joints weather out faster than homeowners expect. The more joints that need repointing, the closer the job gets to a rebuild.
- Roof access and pitch. Steep roofs and tight side yards slow the work down. Our technicians are set up for roof access, but the time it takes is part of the estimate.
- Water intrusion history. A chimney with no cap or a failed crown has been taking water straight down the flue. That shows up as rusted dampers, cracked liners, and interior damage. A proper Gelco cap and crown repair at the right time is far cheaper than a rebuild later.
- Whether it’s a wood-burning fireplace, insert, or a furnace flue. Each one takes a different liner size and a different venting setup. Olympia Chimney and Copperfield components let us match the right size to the appliance instead of forcing a generic liner in.
How to Save on Chimney Liner & Rebuild
Chimney work has no coupons and we’re not going to pretend otherwise. What actually saves money is doing things in the right order.
- Sweep and inspect before anything else. A $150 to $350 inspection can tell you the liner is fine and you don’t need a reline at all. It can also catch a cracked liner before it costs you a rebuild. Either way, you spend less than guessing.
- Restore before you replace. If the clay liner can be resurfaced with HeatShield, do that. It’s the smart middle option between leaving a deteriorating flue alone and paying for a full reline.
- Cap the chimney. A Gelco cap in the $180 to $450 range keeps rain, birds, and West Texas dust out of the flue. It’s the cheapest thing you can do to prevent the $6,000 repair.
- Fix the crown early. A cracked crown lets water into the masonry. Patching it at $400 to $1,200 beats rebuilding the top of the chimney at $3,500 or more.
- Bundle the dryer vent. We clean dryer vents with Famco-compatible components on the same visit as chimney work. One call, one trip, and you’ve handled the other fire-safety system in the house.
- Get a written estimate. Ours is free. Call (866) 942-7865 and we’ll give you a price in writing before any work starts.
One thing we won’t do is tell you a liner is beyond saving when it isn’t. Some sweep-only companies have to turn away deteriorating flue liner jobs because they can’t restore them. We can. That means more Midland homeowners get the HeatShield option before anyone talks about a rebuild.
Why Midland Chimneys Need Liner and Rebuild Work
Chimneys in Midland live through a specific set of conditions. Summer heat pushes mortar joints hard, and the dry air pulls moisture out of brick faster than it goes in, which sounds like a good thing until the freeze nights come around a few times each winter. Add the wind and dust that West Texas is known for, and chimneys that aren’t capped fill up with grit. That grit sits against the liner, holds moisture, and slowly works on the clay.
Most of the homes we see in Midland are wood-burning fireplaces and inserts that get used in the cooler months and sit idle for the rest. That idle time is when a small cracked liner gets worse. If you’re in the neighborhood and haven’t had the flue looked at, the inspection is the first step, and it’s cheaper than waiting.
The other piece is the dryer vent. A clogged dryer vent is one of the leading causes of residential fires in this country, and it’s the same kind of combustion-exhaust problem as a blocked chimney. We clean dryer vents alongside chimney work so both systems in the house get looked at in one visit. That’s what “one call covers it” means here: sweep, repair, and dryer vent from the same specialist.
If you want to know more about how we approach the work across the region, take a look at Midland, or start at Chimney Sweep Midland to see the full scope of what we handle.
When to Reline and When to Rebuild
This is the question that decides most of the money, so it’s worth spelling out.
Resurface when the clay liner is cracked but still standing. HeatShield is a ceramic resurfacing product that goes on the inside of the flue and forms a new lining over the old one. It’s certified work and it’s the right call for a liner that’s weathered but not failing.
Reline when the original liner is broken, missing sections, or too small for the appliance. We install DuraFlex flexible stainless liner systems sized to the flue. This is a same-visit solution for a compromised chimney, which is the whole point. You’re not left with a fireplace you can’t use while someone orders parts.
Rebuild when the masonry itself is failing. That means bricks that are spalling, mortar that’s washed out, a chimney that’s leaning, or a stack that’s separated from the house. A rebuild is the expensive option, and it’s the one we try to avoid by catching problems at the liner and crown stage.
We stock caps, dampers, flashing, and venting components through Famco and Copperfield. Repairs don’t sit waiting on a special order while your chimney stays open to the weather.
FAQs – Chimney Liner & Rebuild Cost
How much does a chimney liner cost in Midland?
A full DuraFlex stainless reline in Midland typically runs $2,200 to $4,800. A HeatShield ceramic resurfacing of a salvageable flue is $450 to $900. The written estimate sets the final price, and the estimate itself is free. Call (866) 942-7865.
Is it cheaper to repair or replace a chimney liner?
Repair is almost always cheaper when the liner can be saved. HeatShield resurfacing at $450 to $900 costs well under half of a $2,200 to $4,800 reline. The camera inspection tells you which one applies. Call (866) 942-7865 to book it.
Do I need a permit for a chimney rebuild in Midland?
Chimney rebuilds and relines usually require a permit from the city, so check with Midland’s building department before work starts. We’ll walk you through what the job involves and what the permit will cover. Call (866) 942-7865 for details.
How long does a chimney reline take?
Most single-story relines are done in a day. Taller chimneys with an offset can take longer. HeatShield resurfacing typically takes a day as well. The estimate gives you a realistic timeframe. Call (866) 942-7865 to schedule.
Can you come today?
Often, yes. We answer 24/7 and dispatch fast from 7am to 7pm, Sunday through Friday. Call (866) 942-7865 and we’ll find you the earliest opening.
What Happens When You Call
You call (866) 942-7865. We answer 24/7. We’ll ask about the chimney, what you’re seeing, and when you last had it looked at. Then we send a technician out with the inspection camera and the tools to tell you what’s actually happening inside the flue. You get a written estimate covering the sweep, any HeatShield resurfacing, a DuraFlex reline, or a rebuild, whichever applies, with the price set per job.
If your fireplace is wood-burning, get it looked at before the next burn season. If you have a dryer that takes longer than it used to, that vent is worth a look too. Chimney Sweep Midland handles both. We’re licensed, insured, and bonded, and the estimate is free. Call (866) 942-7865. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Midland, serving Midland since 2011.
Pricing reflects the Midland market as of 2026. Chimney Sweep Midland offers free estimates – call (866) 942-7865.
What Our Customers Say
"Liner was cracked in two places. He walked me through the repair options honestly, including the one that was cheaper for him and better for me."
- Craig Thompson"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
- Emily Rhodes"Cap keeps the birds out now, which after two springs of scratching noises is worth every penny."
- Travis Norris