Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Cap & Crown Cost in Midland?
In Midland, TX, a chimney cap typically runs $180 to $450 installed, and repairing or rebuilding a chimney crown usually lands between $275 and $1,200 depending on how much masonry has to come out. Getting both done together is common, and a straight rebuild of a badly cracked cap and crown often comes in around $400 to $1,400 on a single-story home. Prices are estimated ranges set per job by a written estimate, so the number you get depends on what we find when we’re on the roof.
Chimney caps and crowns are the cheapest protection on the entire chimney. The cap keeps rain, birds, and debris out of the flue, and the crown is the sloped concrete top that pushes water away from the brick. Midland’s mix of hot, dry summers and sudden spring wind and hail does a real number on both. If either is failing, it’s a small repair that stops a large one. Call (866) 942-7865 for a free estimate. We answer 24/7. Fast dispatch runs from 7am to 7pm, Sunday through Friday.
- Typical cap install: $180 to $450
- Typical crown repair: $275 to $700
- Full crown rebuild: $600 to $1,200
- Cap and crown together: $400 to $1,400
- Custom or oversized cap: $300 to $650
Chimney Cap & Crown Cost Breakdown (2026)
Here’s how the work breaks down for the Midland market in 2026. Each line is an estimated range for that piece of the job. A written estimate will pin down the exact figure once we’ve seen the chimney.
| Line item | Estimated range | What it covers |
|---|---|---|
| Standard single-flue cap | $180 – $320 | Galvanized or stainless steel cap with mesh screen, sized to the flue |
| Multi-flue or oversized cap | $300 – $650 | Larger footprint or custom fabrication for odd chimney dimensions |
| Cap removal, reseat, or replacement | $150 – $350 | Pulling a rusted or damaged cap and fitting the new one |
| Minor crown repair | $275 – $550 | Patching hairline cracks and sealing the surface |
| Full crown rebuild | $600 – $1,200 | Removing failed mortar and pouring a new sloped crown with an overhang |
| Cap and crown together | $400 – $1,400 | Bundled work on the same visit |
| Crown sealant or waterproofing | $150 – $350 | Surface coating to slow water damage on a good crown |
What pushes the number up is almost always access and condition. A tall two-story chimney takes more setup than a low ranch roofline. A crown that’s crumbled to the point the brick needs to be rebuilt at the top is a bigger job than one with a single crack. On the lower end, a simple cap swap is quick. On the higher end, a full rebuild means chipping out the old crown, forming the mortar and new concrete, and giving it the proper slope so water runs off instead of pooling against the flue.
We install caps and covers using Gelco products, and we stock the common sizes so a cap repair isn’t sitting on a special order. We also source materials through Chimney Sweep Midland‘s professional supply lines, which means the cap you get is the trade-grade kind, not a hardware-store basket case that rusts through the first hard season.
What Affects Chimney Cap & Crown Pricing in Midland
- Roof height and access. A single-story Midland ranch home is faster to work on than a two-story with a steep pitch. The labor difference is real and shows up in the estimate. Height means ladder and roof safety setup, and that takes time.
- Chimney material. Brick chimneys in Midland take a crown the traditional way, with a poured or formed concrete top. A chase-style chimney with siding needs different components and often a different cap style. The material drives the parts list.
- Size and number of flues. One flue is the cheapest cap. Two or three flues, or a flue wider than a standard size, need a larger or custom cap, which adds cost.
- Condition of the crown and brick. Hairline cracks are a patch job. Spalling brick at the chimney top, where the crown has been letting water in, means masonry repair around the rebuild. That’s the single biggest swing factor in the price.
- Local weather’s toll. Midland’s dry heat cracks concrete over time, and the wind-driven storms that roll through the Permian Basin can lift or damage a loose cap. Chimneys here see plenty of sun and wind, and both work on the crown and the cap every year.
- Crown sealing or waterproofing. If your crown is sound but aging, a surface sealant is a cheaper option than a rebuild and buys time. We’ll tell you honestly whether it’s the right call or just a patch over a bigger problem.
One thing worth knowing: any time we’re up on the chimney for a cap or crown, we check the flue. In Midland, a cracked crown often means water has been getting into a clay tile liner, and that cracked tile is the real cost driver once it’s discovered. If the liner is failing, we can reline with DuraFlex or, for a flue that’s still salvageable, apply HeatShield ceramic resurfacing. Both are done by our team, so a crown repair doesn’t turn into a separate appointment with a different contractor.
How to Save on Chimney Cap & Crown
The best way to keep the price down is to catch the problem early. A crown that’s sealed before it cracks costs a fraction of a rebuild. So does a cap that gets replaced before the flue has been open to rain for a season.
- Bundle the work. If the cap and crown both need attention, doing them on the same visit saves on setup and labor. Expect to pay less than two separate visits.
- Don’t wait on a crack. A hairline crack in the crown is cheap to seal. Once water has been in there for a couple of Midland summers, the brick at the top starts to fail and the job gets bigger. Sealing early is the biggest savings you’ll find here.
- Get a written estimate before work starts. The estimate is free, and it sets the final price. That means no surprises when the work is done. Call (866) 942-7865 to schedule one.
- Ask about cap style. A standard steel cap is the most economical. Custom caps look nice but cost more, so ask what styles fit your chimney and budget.
- Fix the cap when you fix the crown. If we’re already up there rebuilding the crown, adding the cap is a modest extra. It’s the cheapest moment to do it.
- Keep up with a sweep. A clean flue and a clear cap mean you’ll spot a problem before it spreads. Routine service through Midland costs far less than the repair that neglect causes.
The honest answer is that a cap and crown are not where you want to cut corners. They’re the parts of the chimney that take the weather. Getting trade-grade materials in place is what makes them last.
FAQs – Chimney Cap & Crown Cost
How much does a chimney cap cost in Midland?
A chimney cap in Midland typically costs $180 to $450 installed, with a standard single-flue cap toward the lower end and a multi-flue or custom cap toward the higher end. The cap itself is one of the least expensive chimney parts, and installation is quick once it’s sized correctly. Call (866) 942-7865 for an exact quote, and the estimate is free.
How much does chimney crown repair cost?
Chimney crown repair in Midland usually runs $275 to $700 for a patch-and-seal job and $600 to $1,200 for a full rebuild where the old crown has to come out. The range depends on how much of the concrete and brick at the top has failed. A written estimate sets the final price after we’ve seen it.
Is it cheaper to repair or rebuild a chimney crown?
Repair is cheaper when the damage is surface-level, and a rebuild is cheaper over the long run when the crown has already let water into the brick. A patch job in the $275 to $550 range makes sense on a sound crown with a crack or two. If the crown has crumbled to the point the top of the flue is open to rain, a rebuild at $600 to $1,200 protects the flue and liner from damage that costs far more. We’ll tell you which one your chimney actually needs.
Can you install a chimney cap the same day?
Yes. A standard cap install is usually done on the same visit because we stock the common sizes in Gelco products. If the cap is a custom size, it may take longer to get the right part. Call (866) 942-7865. We answer 24/7. Fast dispatch runs from 7am to 7pm, Sunday through Friday.
How often does a chimney cap or crown need replacing in Midland?
A well-installed trade-grade cap can last many years, but Midland’s sun, wind, and storm seasons shorten the life of cheap galvanized caps, which tend to rust and lift. Crowns crack faster when the concrete was poured thin or without the right slope. The fix is to check both when you have the chimney swept, and reseal the crown early rather than wait. Catching it early is what keeps the cost down.
Why Chimney Sweep Midland for Cap and Crown Work
We’ve served Midland since 2011, and in that time the same thing has stayed true: the cheap cap and the untended crown are what send people back up on the roof a year later. We work with trade brands on purpose. Caps and covers come from Gelco. Liners, when a failing crown has let water into the flue, come from DuraFlex. Salvageable flues get HeatShield ceramic resurfacing instead of a full reline. Damaged crowns, flashing, and venting components come through Olympia Chimney, Famco, and Copperfield. Same supply chain the professional chimney trade uses.
That matters for a cap and crown job because it means we’re not improvising. If the crown is sound we seal it. If it’s failed we rebuild it. If the flue underneath is cracked we reline or resurface it on the same visit rather than hand you a phone number for someone else. Since we also handle dryer vent cleaning, one call covers both the chimney and the other exhaust vent in the house, which is where a lot of residential fire risk actually lives.
We’re a chimney and vent specialist. Sweeping, repair, and dryer vent cleaning are what we do. That focus is why the cap, the crown, and the flue get looked at together instead of one at a time.
Book a Free Cap and Crown Estimate
If you’ve got a missing cap, a rusted one, or a crown with cracks running through it, the price range on this page is a starting point, not a bill. We’ll come out, look at the chimney, and give you a written estimate that sets the final price. No fee for the estimate. Call (866) 942-7865. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Written by the team at Chimney Sweep Midland, serving Midland since 2011.
Pricing reflects the Midland market as of 2026. Chimney Sweep Midland offers free estimates – call (866) 942-7865.
What Our Customers Say
"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
- Shanice Dawson"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
- Javier Martinez"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
- Carmen Guzman